Product Description
JSP Press To Check P3 Dust Filters - Force8 & Force10
KEY DETAILS
-
Individually sealed
-
08-2030 Expiry Date
-
Compatible on Force8™ & Force10™ JSP masks
-
How can you be certain that you have appropriately put on your mask? The Force8 PressToCheck filters, which are now pending patent, allow you to consistently verify that you have the right seal in an instant..
-
Winner of BSIF Product Innovation Award.
-
FIT IT! Don the Mask: Place the harness and straps over your head, making sure the straps are comfortably tight.
-
PRESS IT! PressToCheck™ - To prevent air from passing through the filters, press the front and rear of each filter cover together.
-
CHECK IT! Inhale - The mask shouldn't let any air through. Repeat after adjusting the mask until it doesn't. Once the seal is formed, release.
-
EN Classification 143:2006
-
Complies with European standards - CE Marked
FAQ Section
1. What are JSP Press To Check™ P3 R D Dust Filters?
JSP Press To Check™ P3 R D Dust Filters are high-efficiency particulate filters designed for use with the JSP Force 8 half-mask. These filters provide protection against dust, mist, and fumes, including fine dusts and particulates.
2. How do I fit the Press To Check™ filters to my Force 8 Mask?
To fit the filters, align them with the mask's filter connectors and twist into place until secure. Before use, perform the Press To Check™ test to ensure a good seal: press the fronts of the filters while inhaling gently. If the mask tightens against your face, the fit is secure.
3. How often should I replace my filters?
Filter life depends on several factors, including the level of contaminants, breathing rate, humidity, and temperature. Replace filters when it becomes difficult to breathe comfortably or if the filters are damaged. It's recommended to check the filters regularly for signs of wear.
4. Can these filters protect against gases and vapours?
No, the P3 R D filters are designed for protection against particulates only. For protection against gases and vapours, you would need specific types of filters designed for those hazards.
5. Are the Press To Check™ filters reusable?
Yes, these filters are reusable and designed for more than one work shift. However, they should be replaced if they become damaged, clogged, or if breathing resistance becomes too high.
6. How do I check the fit of my mask with these filters?
Utilise the Press To Check™ feature by pressing the filters inward while inhaling. A proper seal will make the mask slightly collapse onto your face. If air leaks are detected, adjust the mask and retest.
7. Where can I purchase replacement Press To Check™ P3 R D filters?
Replacement filters can be purchased directly from Mendip Safety Supplies or authorised distributors. Ensure you purchase genuine JSP filters to maintain the effectiveness of your mask.
8. Can I use these filters for protection against COVID-19?
While the P3 R D filters are effective against particulates, for biological hazards like viruses, always follow the latest government and health guidance to ensure adequate protection.
9. How should I store my filters when not in use?
Store the filters in a clean, dry place away from contaminants. Ideally, keep them in a sealed bag or container to prevent exposure to dust and moisture.
10. Who can I contact for more information?
For further assistance, please contact Mendip Safety Supplies customer service. We're here to help with product selection, fitting instructions, and any other queries you may have.
This section aims to address common questions and concerns regarding the JSP Press To Check™ P3 R D Dust Filters for the Force 8 Mask, providing clear and concise information to users.
